Search Results for ‘2006’

Hi! The lights on my 4x4 selector push buttons don't come on following ignition. They'll come on as the truck starts like all the other lights on the dash. But after that, nothing. My 2wd light isn't even on as I'm driving. I've tried engaging 4H and 4L as I drove to see if it would engage...

Any guidance on how to separate 2.8 cast AL oil pan from cast AL Block ??? Does NOT respond to Normal methods... Scared to get too rough... have disconnected mounts, etc & raised engine for EXTRA 'swing' room... thanks...

I have an 2006 Colorado with a 3.5 liter engine. It has 110k miles. Last year I started hearing a knock coming from the front of the engine. It has gotten a bit worse over the last 6 months. The sound is present with or without the serpentine belt attached. The knock frequency is half the...

Hey everyone, so I'm having issues where my engines is running lean. I have the code P0171 (Lean), and Crankshaft Postion (P0017, Bank 1) and Camshaft codes(P0365). I'm looking into the lean because data shows I'm running lean on my longterm fuel trims. I've had the camshaft code before and the...

Trying to find out if there is a way to install tow hooks on stock front bumper. I've tried a few websites that showed hooks with mount holes vertical : when parts arrived holes were horizontal .. appears more to places on each side to screw in hardware in an up and down fashion, but are there...

Thought I would share the aftermath of my dechroming and getting rid of the hideous gray that the 1st gen colorados have. And yes that includes the door handles and mirrors. Instead I painted everything black and i thought it turned out really well and was hoping for other peoples opinions. My...

I have a single cab short bed i4 auto from 2006. 178K miles on it and been a pretty good truck since I bought it early 2018. its had a few issues that were easy to fix. throttle body cleaned twice camshaft sensor replaced, new belt and tensioner vapor control system was messed up so I...

Hey, my highest fan setting decided to stop working yesterday. I was wondering what might cause this? My third setting was not working for a long time so I finally replaced the resister and the cable hoping that might be the problem, the connector was highly melted. Now my 3rd setting works...